NUVIS Reverse Osmosis Drinking Water System

Delicious, sparkling-clear, drinking water.

Pristine, flavorful coffees, teas, & juices.

Crystalline, harder, and clearer ice cubes.

Save your money! Stop purchasing wasteful bottled water.

The Nuvis Reverse Osmosis System has Five HIGH PERFORMANCE Filtration Stages

Sediment & Activated Carbon Block Module

Protects the automatic shut-off from clogging with microscopic debris, and where the chlorine is removed to protect the refined Composite Membrane.

Reverse Osmosis Chamber

This is the heart of the system. Particles too small to be trapped by the prefilters are removed by the Composite Membrane, further reducing contaminants.

Granular Activated Carbon

Extended contact Granular Activated Carbon further enhances your waters taste and color.

In-line Polishing Filter

The final stage of filtration, an In-line Polishing Filter, removes any remaining tastes and odors before the water reaches it’s final destination; your drinking glass.

State-of-the-Art Features

Patented DESIGN

Exclusive Patented Manifold Channel Design reduces tubing connections and streamlines installation.

Automatic SHUT-OFF

Space-saving design is ideal for under-the-sink installations.

High Capacity TANK

Holds approximately three gallons of water without taking up a lot of space.

Maximum Production

High Performance Membrane, with a rating of 50 gallons (189 liters) per day out-put.

Technical Support Information

Performance Specifications

PrefilterSediment /Activated Carbon Block Module
MembraneThin Film Composite Module
Extended Contact FilterGAC Module
Post FilterIn-Line Carbon Module

Filter Module Components

Membrane Production1
Membrane Production41 – 53 gallons per day
Membrane TDS Reduction96% Minimum
System Production14 gallons per day
System TDS Reduction93% Average

Incoming Water Specifications

Water Pressure40-100 psig
Total Dissolved Solids TDS2000 ppm maximum
pH4-11 (optimum rejection at pH 7.0 – 7.5)
HardnessLess than 10 gpg or conditioner softened
IronLess than 0.1 ppm
ManganeseLess than 0.05 ppm
Hydrogen SulfideNONE
Chlorine2See note below
Bacteria3Water source must be potable
Temperature40°F – 100°F
 
  1. Measured at industry standard condition of 65 psig (448 kPa), 77°F (25°C), 600ppm (mg/l) T.D.S., and a discharging to atmosphere.
  2. Chlorine will damage a T.F.C. Membrane. The Activated Carbine Block Filter will remove chlorine from the incoming water.
    Change the cartridge every 12 months; more often if your water contains more than 1 ppm chlorine.
  3. Do not use with water that is micro-biologically unsafe or of unknown quality, without adequate disinfection before or after the system